FAQs

Frequently Asked Questions (FAQs)

Press and hold the 0 key and enter a user code, press 6 (“Phone Numbers”), set up to 4 telephone numbers, and press ENTER.

If the fault occurs after a prolonged power outage, wait a few hours after power returns for the battery to recharge. If the fault message is still displayed, the battery may have reached its end of life cycle, and should be replaced with a new one.
Attention! The alarm system does not work without a backup battery if a power outage occurs. Call service.

Press and hold the 0 key and enter a user code, press 0 (“Auto Arming”), set a daily arming time, and press ENTER.

The “Home” arming modes are to be used during the night and are set by a service technician. If the technician already set them, you can arm to Home 1 or Home 2 modes.

Press and hold the 0 key and enter a user code, press 8, set time and date, and press ENTER.

Press and hold the 0 key and enter a user code, press 9 (“User Codes”), press NEXT to the desired user, press ENTER, set the code, and press ENTER.

Press and hold the 0 key and enter a user code, press 3, enter the faulted zone number, and press ENTER. The zone is immediately bypassed and will not trigger the alarm if it is violated when the alarm system is armed. The zone is reinstated after each arming session. If the fault continues, call service.

Using PIMAlink 2.0 cloud application for Android and iOS. To use the application the alarm system must be connected to the Internet.

Press the END+ENTER keys at the same time to mute all keypad audible indications (including the doors and windows chime). After fixing the fault, press the two keys again to reactivate the keypad sound.

Press and hold the 0 key and enter a user code, press the asterisk key, enter the desired door’s zone number, and press ENTER.

Remote controlling the AlarmView+ is simple thanks to the PIMAlink 2.0 app.
PIMALink 2.0 app is available for free on Google Play and Apple Store.

Yes, there are two options:

  1. Using a keyfob
  2. Using PIMAlink 2.0 app

On the upper right corner of the LCD display there is a signal bar. Verify that there are more than 3 bars.

There are three options:

  1. Full away – the entire system
  2. Home 1 – partial arming for a pre-selected zone
  3. Partial – partial arming for an alternative pre-selected zone

One AA 3.6V Lithium battery.

After installing PIMALink 2.0 App and pair a device to your AlarmView+, select EDIT on the App, log in with your Master code to the panel and enable\disable the remote look-in option.

Prepaid SIM cards can be used, but the panel can’t notify you when it runs out of credit.

During installation, ask your installer to enable the restriction option.
Once this option is enabled, the Master code will be required to allow access to the Installer menu.

CONTACT US